Setting the
Light Times
Press and hold the square push button approximately 4 seconds
until time-setting LED (located below push-button) lights up.
When the button is released the SYNC-5 will begin it's cycle.
Simply press the button when you want the cycle to advance.
Button press #1 sets the WALK-GREEN-LIGHT time. (sets the GREEN
LIGHT time for the 3-Banger circuit board)
Button press #2 sets the GREEN-LIGHT time.
(sets the YELLOW LIGHT
time for the 3-Banger circuit board)
Button press #3 sets the YELLOW-LIGHT time.
(sets the RED LIGHT time for the 3-Banger
circuit board)
Button press #4 sets the RED-LIGHT time.
After the #4 button press, the PROGRAM LED LIGHT will turn off.
Time setting is complete The unit will then begin to cycle as
normal.
If you make a mistake in the middle of the programming procedure,
remove power from the unit, wait 5 seconds,
apply power and begin the programming procedure again.
[BACK]
Free counters provided by Andale.